LED日光灯安装方法
LED
SD-L18A SD-L08A
English Installation Method
日本語 インストール方法
1、确认光管支架为电感式。
2、关掉电源,取下启辉器。
3、装上LED 灯管然后开电源。
1, confirmed that fluorescent tubes for the inductive stent. 2, switch off the power, remove the starter
device. 3, fitted with power LED lamp and then opened. 1 、確認は、誘導性ステントの蛍光管。 2
は、始動装置を削除して電源をOFF に切り替えま
す。 3 、電源とランプのLED を搭載している。
Starter device
始動装置
启辉器
LEDのエネルギーの高さの均一性の省エネランプSD-L18AT1SD-L08AT
1
English Installation Method
日本語 インストール方法
1.确定好要安装的位置。
2.将两个卡扣用螺丝锁在要安装的位置上。两卡扣之间距离以灯管长度一半为最佳。
3.将灯管上的两根输入线分别接在零,火线上.
4.装上LED 灯管
1. インストールしても良い場所を特定するには
2. 2つのロックネジで、
その2つのロックとの間の距離が固定されているランプチューブのより良い半分の長さです。
3 . ゼロで、次の2つの入力ライン上のランプは、それぞれ、火の行。
4. LED ランプを搭載。
1
2
3 4
one
1. To determine a good location to install.
2. The two locks are fastened with screws, and the
distance between the two locks is better half length of the lamp tube.
3. The lamp on the next two input lines, respectively, in zero, the line of fire.
4. Fitted with LED
lamp. two
three four
1 2
3 4
灯长1/2
Light a long 1 / 2
光は長い1/2
LEDのエネルギーの高さの均一性の省エネランプSD-L18AT2SD-L08AT
2
English Installation Method
日本語 インストール方法
1.确定好要安装的位置。
2.将两个卡扣用螺丝锁在要安装的位置上。两卡扣之间距离以灯管长度一半为最佳。
3.将灯管上的两根输入线分别接在零,火线上.
4.装上LED 灯管
1. インストールしても良い場所を特定するには
2. 2つのロックネジで、
その2つのロックとの間の距離が固定されているランプチューブのより良い半分の長さです。
3 . ゼロで、次の2つの入力ライン上のランプは、それぞれ、火の行。
4. LED ランプを搭載。
1
2
3 4
one
1. To determine a good location to install.
2. The two locks are fastened with screws, and the
distance between the two locks is better half length of the lamp tube.
3. The lamp on the next two input lines, respectively, in zero, the line of fire.
4. Fitted with LED
lamp. two
three four
1 2
3 4
灯长1/2
Light a long 1 / 2
光は長い1/2