IEC标准对应表

62271-203@IEC:2003

Common numbering of IEC 62271 publications falling under the responsibility

IEC 62271 series HIGH-VOLTAGE SWITCHGEAR AND CONTROLGER

高压开关设备和控制设备

Old IEC number

if any

part New title

1 Common specifications

通用说明

IEC 60694

2 Seismic qualification for rated voltages of 72.5Kv and above

72.5kV及以上设备抗地震性能

-

100 High-voltage alternating current circuit-breakers

高压交流断路器

IEC 60056

101 Synthetic testing

合成测试

IEC 60427

102 High-voltage alternating current disconnections and earthing switches

高压交流隔离开关和接地开关

IEC 60129

103 Switches for rated voltages above 1kV and less than 52kV

1kV～52kV的开关设备

IEC 60265-1

104 Switches for rated voltages of 52 kV and above

52kV及以上的高压开关设备

IEC 60265-2

105 Alternating current switch-fuse combinations

高压交流开关－熔断器组合

IEC 60420

106 Alternating current contactors and contactor-based motor-starters

交流接触器和

IEC 60470

107 Alternating current switchgear-fuse combinations

高压交流开关设备－熔断器组合

-

108 Switchgear having combined function

开关设备的联动功能

-

109 Series capacitor by-pass switches

串连电容器

-

200 AC metal-enclosed switchgear and control gear for rated voltage above

1kV and up to and including 52 kV

1kV～52 kV 交流金属封闭开关和控制设备

IEC 60298

201 Insulation-enclosed switchgear and controlgear for rated voltage up to

and including 52 kV

52 kV及以上绝缘封闭开关设备

IEC 60466

202 High-voltage/ Low-voltage prefabricated substations

高低压箱式变电站

IEC 61330

203 Gas-insulated metal-enclosed switchgear for rated voltages above 52 kV

额定电压在52 kV以上气体绝缘金属封闭开关设备

IEC 60517 204 High-voltage gas-insulated transmission lines for rated voltages of 72.5 IEC 61640

62271-2003◎IEC:2003

Table 102-Preferred rated insulation levels for rated voltages

62271-2003◎IEC:2003

Table 103-Preferred rated insulation levels for rated voltages

for equipment of range II

页脚内容

NOTE(3) Values in column(2) are applicable:

(a)for type tests ,phase-to-earth and between phases;

(b)for routine tests, phase-to-earth, phase-to-phase, and across the open switching device.

Values in columns(3), (4), (5), (6), (7) and (8) are applicable for type tests only.

NOTE(4) these values are derived using the multiplying factors stated in Table 3 of IEC 60070-1(1993) 注1：第6列也适用于一些断路器，参见IEC 62271-100.

注2：在第6列，括号内的数字是加在同一极相应端子上的反极性工频电压的峰值。

注3：第二列种的数字适用于：

相间试验类型

相对地，相间和通过断开的开关设备间的常规测试

(3), (4), (5), (6), (7)和(8) 列种的数值仅用于典型测试

注4：

页脚内容