运输工具检验程序和密封程序
Conveyance Inspection Procedures and Sealing Process
运输工具检查程序&封条使用过程
Presented by
SSCSS Mark Isaacson
SCSS Tom Greulich
SCSS Mark Mahoney
Objectives 目标? Systematic 17-point conveyance inspection process 17点系统运输工具检查过程? Identifying security breaches 识别安全漏洞 ? Sealing Criteria 密封标准 ? Seal inspection procedures 密封检查程序
17-Point Truck & Trailer Inspection
17个货车和拖车检查点
1. Bumper 保险杠
2. Engine 发动机
3. Tires (truck & trailer)轮胎(货车和拖车)
4. Floor (inside truck)车厢地面(货车内)
5. Fuel Tanks油箱
6. Cab/ Storage Compartments
驾驶室/存储隔间
7. Air Tanks储气罐
8. Drive Shafts传动轴
9. Fifth Wheel备用轮胎
10. Outside/ Undercarriage外/底盘
11. Floor (inside)车厢底(车内部)
12. Outside/ Inside Doors外面/里面的门
13. Side Walls侧壁
14. Ceiling/ Roof车内天花板/车顶
15. Front Wall前壁
16. Refrigeration Unit制冷装置
17. Exhaust排气管
Conduct a Systematic Inspection 进行系统的检查
Begin and end your inspection at the same point every time.
每次检查时开始和结束于同一点。
Bumpers 保险杠Point 1
Engine Area 发动机区域
Tires 轮胎
Tires 轮胎
? Recently Mounted 最近安装的 ? Tampered Bolts 篡改螺栓 ? Water Streaks 出现水痕
Floor车厢底
油箱/蓄电池箱
Fuel Tank Compartment油箱舱
Fuel Tank油箱
Cab/Sleeper驾驶室/卧车
Storage Compartment存储隔间
Air Tanks储气罐
Drive Shaft传动轮
Fifth Wheel Area 放置备用轮胎区域
False Floor in Fifth Wheel
Fifth Wheel Area
放置备用轮胎的假底