ARUBA的AP如何恢复出厂设置
开机用console线接入
APBoot 1.2.4.4 (build 26618)
Built: 2011-01-07 at 13:42:04
Model: AP-10x
CPU: AR7161 revision: A2
Clock: 680 MHz, DDR clock: 340 MHz, Bus clock: 170 MHz
DRAM: 128 MB
POST1: passed
Copy: done
Flash: 16 MB
PCI: scanning bus 0 ...
dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3
00 00 168c 0029 00002 01 10000000 00000000 00000000 00000000
01 00 168c 0029 00002 01 10010000 00000000 00000000 00000000
Net: eth0
Radio: ar922x#0, ar922x#1
Hit
apboot> 视图apboot>
apboot> factory_reset ---------------------------命令1
Clearing state... Checking OS image and flags
Image is signed; verifying checksum... passed
Dont_clear flag set -- skipping OS clear
Erasing flash sector @ 0xbff70000....done
Erased 1 sectors
Erasing flash sector @ 0xbff80000....done
Erased 1 sectors
Erasing flash sector @ 0xbff90000....done
Erased 1 sectors
Erasing flash sector @ 0xbffb0000....done
Erased 1 sectors
Erasing flash sector @ 0xbffc0000....done
Erased 1 sectors
Erasing flash sector @ 0xbffd0000....done
Erased 1 sectors
done
Purging environment... Un-Protected 1 sectors
.done
Erased 1 sectors
Writing
done
apboot> pur ----------------命令2
Un-Protected 1 sectors
.done
Erased 1 sectors
Writing
apboot> reset ------------------命令3
（此命令输入回车后ap会重
启，重启完成以后会恢复出厂成功）APBoot 1.2.4.4 (build 26618)
Built: 2011-01-07 at 13:42:04
Model: AP-10x
CPU: AR7161 revision: A2
Clock: 680 MHz, DDR clock: 340 MHz, Bus clock: 170 MHz
DRAM: 128 MB
POST1: passed
Copy: done
Flash: 16 MB
PCI: scanning bus 0 ...
dev fn venID devID class rev MBAR0 MBAR1 MBAR2 MBAR3
00 00 168c 0029 00002 01 10000000 00000000 00000000 00000000
01 00 168c 0029 00002 01 10010000 00000000 00000000 00000000
Net: eth0
Radio: ar922x#0, ar922x#1
.........................
..........................
..............................
.............................
.............................
.............................
.............................