FXO-HC335R-14.31818;FXO-HC335R-4;FXO-HC335R-48;FXO-HC335R-40;中文规格书,Datasheet资料

Model: FXO-HC33 SERIES

Page 1 of 24

HCMOS 3.2 x 2.5mm 3.3V Oscillator

Freq: 0.75 MHz to 250MHz

Rev.3/27/2012

Features

X TREMELY Low Jitter Low Cost X PRESS Delivery

Frequency Resolution to six decimal places Stabilities to ± 25 PPM -20 to +70°C or -40 to +85°C operating temperatures Tri-State Enable / Disable Feature

Industry Standard Package, Footprint & Pin-Out Fully RoHS and REACH compliant Gold over Nickel Termination Finish

Applications

? ANY application requiring an oscillator ? SONET ? Ethernet

? Storage Area Network ? Broadband Access

? Microprocessors / DSP / FPGA ? Industrial Controllers

? Test and Measurement Equipment ?Fiber Channel

Contents

page

Model Selection & Part Number Guide 2 Electrical Characteristics 3 Absolute Maximums 4 Output Wave Characteristics 4 Phase Noise 5 Jitter 5 Pin Assignment 6 Recommended Circuit 6

Reflow 6 Mechanical Drawing and Pad Layout 7 Tape and Reel Specification 8

Label 8 Traceability – LOT Number & Serial Identification 9 SGS Report 10~13 REACH Report 14~21 Mechanical Test 22 Burn-In Test 22 MTTF / FITS calculations 23 Other X PRESS O Links 24 Fox Contact Information 24

Description

The Fox X PRESS O Crystal Oscillator is a

breakthrough in configurable Frequency Control Solutions. X PRESS O utilizes a family of

proprietary ASICs, designed and developed by Fox, with a key focus on noise reduction technologies. The 3rd order Delta Sigma Modulator reduces noise to the levels that are comparable to traditional Bulk Quartz and SAW oscillators. The ASICs family has ability to select the output type, input voltages, and temperature performance features.

With the X PRESS lead-time, low cost, low noise, wide frequency range, excellent ambient performance, XpressO is an excellent choice over the conventional technologies.

Finished X PRESS O parts are 100% final tested.

Model Selection Guide & Fox Part Number

STEP #1:Customer selects the Model Description and provides to Fox Customer Service Model Description

F X O – H C 3 3 5 R – 1 0 6 . 2 5 Frequency (in MHz)

Resolutions to 6 places

past the decimal point This example, FXO-HC335R-106.25 = HCMOS Output, Ceramic 3.2 x 2.5mm Package, 3.3V,

±50 PPM Stability, -40 to +85°C Temperature Range, at 106.25 MHz

Electrical Characteristics

Parameters Symbol Condition

Maximum Value (unless otherwise noted)

Frequency

Range F O0.750 to 250.000 MHz

Frequency

Stability 1-20 ~ +70°C

-40 to +85°C

100, 50, 25* PPM

100, 50 PPM

Temperature

Range

T O

T STG Standard operating

Optional operating

Storage

-20°C to +70°C

-40°C to +85°C

-55°C to +125°C

Supply

Voltage V DD Standard 3.3 V ± 5%

Input

Current (@ 15pF LOAD)I DD

0.75 ~ 20 MHz

20+ ~ 50 MHz

50+ ~ 130 MHz

130+ ~ 200 MHz

200+ ~ 250 MHz

32 mA

35 mA

47 mA

55 mA

60 mA

Output

Load HCMOS

Standard

Operational To 125MHz

15 pF

30 pF

Start-Up

Time T S10

mS Output Enable / Disable Time 100 nS

Moisture Sensitivity Level MSL JEDEC J-STD-20 1 Termination

Finish Au

1I nclusive of 25°C tolerance, operating temperature range, input voltage change, load change, aging, shock and vibration. *Excludes aging.

Absolute Maximum Ratings (Useful life may be impaired. For user guidelines only, not tested)

Parameters Symbol Condition

Maximum Value (unless otherwise noted)

Input

Voltage V DD–0.5V to +5.0V

Operating

Temperature T AMAX–55°C to +105°C

Storage

Temperature T STG–55°C to +125°C

Junction

Temperature 150°C ESD

Sensitivity HBM Human Body Model >1 kV

If 30% to 70% times are used, Rise and Fall times change to 1.5 nS from 0.75 to 250MHz If 20% to 80% times are used, Rise and Fall times change to 2 nS from 0.75 to 150MHz

Output Wave Characteristics

Parameters

Symbol

Condition

Maximum Value

(unless otherwise noted)

Output LOW Voltage V OL 0.75 to 150 MHz 150+ to 250 MHz 10% V DD

20% V DD

Output HIGH Voltage

V OH 0.75 to 150 MHz 150+ to 250 MHz 90% V DD MIN 80% V DD MIN Output Symmetry (See Drawing Below) @ 50% V DD Level

45% ~ 55% Output Enable (PIN # 1) Voltage V IH

≥70% V DD Output Disable (PIN # 1) Voltage V IL

≤ 30% V DD Cycle Rise Time (See Drawing Below) T R 0.75 to 150 MHz 150+ to 250 MHz 3 nS (10%~90%) 3 nS (20%~80%)

Cycle Fall Time (See Drawing Below)

T F

0.75 to 150 MHz 150+ to 250 MHz

3 nS (90%~10%) 3 nS (80%~20%)

156.25MHz -60

-40-200Data Collected using HP 3048A Four Frequencies from Jitter Tables 62.5MHz only to 2MHz offset due to Equipment Limitation

Jitter is frequency dependent. Below are typical values at select frequencies.

Phase Jitter is integrated from HP3048 Phase Noise Measurement System; measured directly into 50 ohm input; V DD = 3.3V. TIE was measured on LeCroy LC684 Digital Storage Scope, directly into 50 ohm input, with Amherst M1 software; V DD = 3.3V. Per MJSQ spec (Methodologies for Jitter and Signal Quality specifications)

Rj and Dj , measured on LeCroy LC684 Digital Storage Scope, directly into 50 ohm input, with Amherst M1 software. Per MJSQ spec (Methodologies for Jitter and Signal Quality specifications)

Phase Jitter & Time Interval Error (TIE)

Frequency

Phase Jitter

(12kHz to 20MHz)

T I E

(Sigma of Jitter Distribution)

Units

62.5 MHz 0.8 2.9 pS RMS 106.25 MHz 0.8 3.2 pS RMS 125 MHz 0.8 2.3 pS RMS

156.25 MHz

1.0

3.0

pS RMS

Random & Deterministic Jitter Composition

Frequency

Random (Rj) (pS RMS) Deterministic (Dj) (pS P-P)

Total Jitter (Tj)

(14 x Rj) + Dj

62.5 MHz 1.2 9.2 25.6 pS 106.25 MHz 1.3 9.0 27.2 pS 125 MHz 1.2 8.7 26.5 pS

156.25 MHz

1.2

12.7

30.0 pS

Phase Noise 3.3V Phase Noise Graphs (dBc/Hz vs. offset frequency

NOTE: X PRESS O HCMOS XOs are designed to fit on Industry Standard, 4 pad layouts

Pin Description and Recommended Circuit

Pin #

Name

Type

Function

1 E / D 1

Logic Enable / Disable Control of Output (0 = Disabled) 2 GND Ground Electrical Ground for V DD 3

Output Output HCMOS Oscillator Output

4 V DD 2

Power Power Supply Source Voltage

T est P oints

N. C.

Hi Z

No Connection (Factory Use ONLY)

NOTES:

1 Includes pull-up resistor to V DD to provide output when the pin (1) is No Connect.

Installation should include a 0.01μF bypass capacitor placed between V DD

(Pin 4) and GND (Pin 2) to minimize power supply line noise.

Mechanical Dimensional Drawing & Pad Layout

Actual part marking

is depicted.

See Traceability (pg. 8) for more information

3.2 x 2.5 XpressO

3.3 Max

1.0 Max

HCMOS

Tape and Reel Dimensions

4.0mm

?1.5mm

3.5mm

8.0mm

766-106.25-8

2000

FXO-HC335R-106.25

Traceability – LOT Number & Serial Identification

LOT Number

The LOT Number has direct ties to the customer purchase order. The LOT Number is marked on the “Reel” label, and also stored internally on non-volatile memory inside the X PRESS O part. X PRESS O parts that are shipped Tape and Reel, are also placed in an Electro Static Discharge (ESD) bag and will have the LOT Number labeled on the exterior of the ESD bag.

3rd Party (SGS) Material Report

分销商库存信息:

FOX-ELECTRONICS

FXO-HC335R-14.31818FXO-HC335R-4FXO-HC335R-48

FXO-HC335R-40FXO-HC335R-33.333FXO-HC335R-33

FXO-HC335R-32FXO-HC335R-30FXO-HC335R-27

FXO-HC335R-26FXO-HC335R-25FXO-HC335R-24.576 FXO-HC335R-24FXO-HC335R-20FXO-HC335R-16

FXO-HC335R-12FXO-HC335R-10FXO-HC335R-8

FXO-HC335R-66.666FXO-HC335R-50FXO-HC335R-106.25 FXO-HC335R-100FXO-HC335R-125FXO-HC335R-150

FXO-HC335R-156.25FXO-HC335R-74.25FXO-HC335R-12.288 FXO-HC335R-2FXO-HC335R-66FXO-HC335-50

FXO-HC330-51.2FXO-HC330-50FXO-HC330-25.175 FXO-HC330-25FXO-HC330-24FXO-HC330-19.2

FXO-HC330-12.288FXO-HC330-6FXO-HC330-4

FXO-HC330-3.6864FXO-HC330-1FXO-HC330-62.4

FXO-HC330R-48FXO-HC330R-37.5FXO-HC330R-33.333 FXO-HC330R-33.3FXO-HC330R-32FXO-HC330R-28.636364 FXO-HC330R-26FXO-HC330R-25FXO-HC330R-22.7728 FXO-HC330R-21.7728FXO-HC330R-21.7725FXO-HC330R-20

FXO-HC330R-19.6608FXO-HC330R-14.31818FXO-HC330R-8.192 FXO-HC330R-6FXO-HC330R-4FXO-HC330R-3.2

FXO-HC330R-1FXO-HC335-54FXO-HC335-52

FXO-HC335-48FXO-HC335-40FXO-HC335-39.2

FXO-HC335-36FXO-HC335-33.333FXO-HC335-33.33

FXO-HC335-33FXO-HC335-30FXO-HC335-29.492 FXO-HC335-27FXO-HC335-26FXO-HC335-25

FXO-HC335-24.576FXO-HC335-24FXO-HC335-22.8

FXO-HC335-22.4FXO-HC335-20FXO-HC335-14.7456 FXO-HC335-12.8FXO-HC335-12.288FXO-HC335-12

FXO-HC335-10.24FXO-HC335-10FXO-HC335-6.14

FXO-HC335-5FXO-HC335-4FXO-HC335-3.6864 FXO-HC335-1.024FXO-HC330R-62.5FXO-HC335-68

FXO-HC335-67.3FXO-HC335-66.666FXO-HC335-66.66

FXO-HC335-66.6FXO-HC335-65FXO-HC335-63

FXO-HC335R-43FXO-HC335R-36.864FXO-HC335R-33.3333 FXO-HC335R-29.4912FXO-HC335R-22FXO-HC335R-19.44 FXO-HC335R-16.5FXO-HC335R-8.448FXO-HC335R-7.3728 FXO-HC335R-4.9152FXO-HC335R-3.6864FXO-HC335R-1

FXO-HC335-75FXO-HC335-70FXO-HC335R-64

FXO-HC335R-74.1758FXO-HC335R-70FXO-HC335-80

FXO-HC335R-80FXO-HC335-98FXO-HC335-95