卡特故障码表

美瑞特维修厂分享,卡特彼勒挖掘机330C故障/事件代码中英对照表
故障代码
Engine Control 发动机控制器 (MID No. 036)
CID Component 元件
0001 Injector Solenoid 1st Cylinder 1#缸喷油器电磁阀
0002 Injector Solenoid 2nd Cylinder 2#缸喷油器电磁阀
0003 Injector Solenoid 3rd Cylinder 3#缸喷油器电磁阀
0004 Injector Solenoid 4th Cylinder 4#缸喷油器电磁阀
0005 Injector Solenoid 5th Cylinder 5#缸喷油器电磁阀
0006 Injector Solenoid 6th Cylinder 6#缸喷油器电磁阀
0041 8V DC Supply 8V直流电源
0042 Injection Actuation Control Valve 喷油器促动控制阀
0091 Throttle Position Signal 油门位置信号
0094 Fuel Pressure Sensor 燃油压力国传感器
0100 Engine Oil Pressure Sensor 发动机机油压力传感器
0110 Engine Coolant Temperature Sensor 发动机冷却液温度传感器
0164 Injector Actuation Pressure 喷油器促动压力
0168 System Voltage 系统电压
0172 Intake Manifold Air Temperature 进气岐管空气温度
0175 Engine Oil Temperature Sensor 发动机机油温度传感器
0190 Engine Speed Sensor 发动机速度传感器
0253 Personality Module 个性模块
0261 Engine Timing Calibration 发动机正时校验
0262 5V Sensor DC Power Supply 5V传感器直流电源
0268 Check Programable Parameters 检查可编程参数
0273 Turbo Outlet Pressure Sensor 涡轮增压器出口压力传感器
0274 Atmospheric Pressure Sensor 大气压力传感器
0286 Oil Lamp 机油灯
0342 Secondary Engine Speed Sensor 次级发动机速度传感器
0617 Air Inlet Heater Relay 空气进气加热继电器
1627 Fuel Pump Relay 燃油泵继电器

Engine / Pump Control 发动机/泵控制器 (MID No. 105)
CID Component 元件
0091 Throttle Position Signal 油门位置信号
0096 Fuel Level Sensor 燃油油位传感器
0110 Engine Coolant Temperature Sensor 发动机冷却液温度传感器
0167 Alternator 发电机
0168 Voltage Of The Power Supply (Keyswitch) 钥匙门电压
0190 Speed Sensor 速度传感器
0248 Cat Data Link CAT数据线
0286 Signal For Low Engine Oil Pressure 发动机机油压力低信号
0374 Swing Brake Solenoid 回转制动电磁阀
0376 Travel Alarm 行走警报
0581 "Proportional Reducing Valve For The Powershift Pressure" 动力换档比例减压阀
0586 Engine Speed Dial 发动机速度盘式开关
0587 Feedback Sensor For The Governor Actuator 调节器传动装置反馈信号
0590 Engine Controller 发动机控制器
0598 Travel Speed Solenoid 行走速度电磁阀
0600 Hydraulic Oil Temperature Sensor 液压油温传感器
1161 Pump Delivery Pressure 泵压
1162 Pump Delivery Pressure 泵压
1524 "Proportional Solenoid Valve For
Negative Flow Control" 负流量控制比例电磁阀
1525 Straight Travel Solenoid 直线行走电磁阀
1590 "Proportional Solenoid Valve For
Negative Flow Control" 负流量控制比例电磁阀
2002 Action Alarm 警报

FMI 故障描述
0 Data valid but above

normal operationl range 数据正确，但高于正常范围
1 Data valid but below normal operationl range 数据正确，但低于正常范围
2 Data erratic,intermittent ,or incorrect 数据不稳，断续或不正确
3 Voltage above normal or shorted high 电压高于正常或突然高
4 Voltage below normal or shorted low 电压低于正常或突然低
5 Current below normal or open circuit 电流低于正常或开路
6 Current above normal or grounded circuit 电流高于正常或短路
7 Mechanical system not responding properly. 机器系统没有正确反应
8 Abnormal frequency, pulse width, or period. 异常频率、脉冲或周期
9 Abnormal update. 异常更新
10 Abnormal rate of change. 异常变化率
11 Failure mode not identifiable. 故障模式不能确认
12 Bad device or component. 坏的设备或元件
13 Out of calibration. 超出校验范围
14-31 Reserved