FSBB30CH60F_060428

44mm26.8mmFigure 1.12V S(U)High-side Bias Voltage Ground for U Phase IGBT Driving 13IN(VH)Signal Input for High-side V Phase14V CC(VH)High-side Bias Voltage for V Phase IC15V B(V)High-side Bias Voltage for V Phase IGBT Driving16V S(V)High-side Bias Voltage Ground for V Phase IGBT Driving 17IN(WH)Signal Input for High-side W Phase18V CC(WH)High-side Bias Voltage for W Phase IC19V B(W)High-side Bias Voltage for W Phase IGBT Driving20V S(W)High-side Bias Voltage Ground for W Phase IGBT Driving 21N U Negative DC–Link Input for U Phase22N V Negative DC–Link Input for V Phase23N W Negative DC–Link Input for W Phase24U Output for U Phase25V Output for V Phase26W Output for W Phase27P Positive DC–Link InputControl Part Total System Thermal Resistance Note:2. For the measurement point of case temperature(T C ), please refer to Figure 2.Package Marking and Ordering InformationSymbolParameterConditionsRatingUnitsV CC Control Supply Voltage Applied between V CC(UH), V CC(VH), V CC(WH), V CC(L) -COM20V V BS High-side Control Bias VoltageApplied between V B(U) - V S(U), V B(V) - V S(V), V B(W) -V S(W)20V V IN Input Signal Voltage Applied between IN (UH), IN (VH), IN (WH), IN (UL), IN (VL),IN (WL) - COM-0.3~17V V FO Fault Output Supply Voltage Applied between V FO - COM -0.3~V CC +0.3V I FO Fault Output CurrentSink Current at V FO Pin5mA V SCCurrent Sensing Input Voltage Applied between C SC - COM-0.3~V CC +0.3VSymbolParameterConditionsRatingUnitsV PN(PROT)Self Protection Supply Voltage Limit (Short Circuit Protection Capability)V CC = V BS = 13.5 ~ 16.5VT J = 125°C, Non-repetitive, less than 2µs 400V T C Module Case Operation Temperature -20°C ≤ T J ≤ 125°C, See Figure 2-20 ~ 100°C T STG Storage Temperature -40 ~ 125°C V ISOIsolation Voltage60Hz, Sinusoidal, AC 1 minute, Connection Pins to DBC substrate2500V rmsSymbolParameterCondition Min.Typ.Max.UnitsR th(j-c)Q Junction to Case Thermal ResistanceInverter IGBT part (per 1/6 module) --0.97°C/W R th(j-c)FInverter FWD part (per 1/6 module)-- 1.77°C/WDevice MarkingDevicePackageReel SizeTape WidthQuantityFSBB30CH60FFSBB30CH60FSPM27EA--10Note:4. Short-circuit current protection is functioning only at the low-sides.5. The fault-out pulse width t FOD depends on the capacitance value of C FOD according to the following approximate equation : C FOD = 18.3 x 10-6 x t FOD [F]Recommended Operating Conditions∆TSDOver-temperature protection hysterisisTemperature at LVIC -18-°C UV CCD Supply Circuit Under-Voltage ProtectionDetection Level 10.711.913.0V UV CCR Reset Level 11.212.413.2V UV BSD Detection Level 10.111.312.5V UV BSR Reset Level10.511.712.9V t FODFault-out Pulse WidthC FOD = 33nF (Note 5)1.01.8-msSymbolParameterConditionsValueUnitsMin.Typ.Max.V PN Supply Voltage Applied between P - N U , N V , N W-300400V V CC Control Supply Voltage Applied between V CC(UH), V CC(VH), V CC(WH),V CC(L) - COM13.5-16.5V V BSHigh-side Bias VoltageApplied between V B(U) - V S(U), V B(V) - V S(V),V B(W) - V S(W)13-18.5V DV CC /Dt, DV BS /Dt Control supply variation -1-1V/µst dead Blanking Time for Preventing Arm-short For Each Input Signal 2.5--µsf PWM PWM Input Signal-20°C ≤ T C ≤ 100°C, -20°C ≤ T J ≤ 125°C --20kHz V SENVoltage for Current SensingApplied between N U , N V , N W - COM (Including surge voltage)-44VDISCLAIMERFAIRCHILD SEMICONDUCTOR RESERVES THE RIGHT TO MAKE CHANGES WITHOUT FURTHER NOTICE TO ANY PRODUCTS HEREIN TO IMPROVE RELIABILITY, FUNCTION OR DESIGN. FAIRCHILD DOES NOT ASSUME ANY LIABILITY ARISING OUT OF THE APPLICATION OR USE OF ANY PRODUCT OR CIRCUIT DESCRIBED HEREIN; NEITHER DOES IT CONVEY ANY LICENSE UNDER ITS PATENT RIGHTS, NOR THE RIGHTS OF OTHERS.LIFE SUPPORT POLICYFAIRCHILD’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF FAIRCHILD SEMICONDUCTOR CORPORATION.As used herein:1. Life support devices or systems are devices or systems which,(a) are intended for surgical implant into the body, or (b) support or sustain life, or (c) whose failure to perform when properly used in accordance with instructions for use provided in the labeling, can be reasonably expected to result in significant injury to the user.2. A critical component is any component of a life support device or system whose failure to perform can be reasonably expected to cause the failure of the life support device or system, or to affect its safety or effectiveness.PRODUCT STATUS DEFINITIONSDefinition of TermsDatasheet Identification Product Status DefinitionAdvance Information Formative or InDesign This datasheet contains the design specifications for product development. Specifications may change in any manner without notice.Preliminary First Production This datasheet contains preliminary data, andsupplementary data will be published at a later date.Fairchild Semiconductor reserves the right to makechanges at any time without notice in order to improvedesign.No Identification Needed Full Production This datasheet contains final specifications. FairchildSemiconductor reserves the right to make changes atany time without notice in order to improve design.Obsolete Not In Production This datasheet contains specifications on a productthat has been discontinued by Fairchild semiconductor.The datasheet is printed for reference information only.Rev. I15。