编译与调试

（1），error: error reading file 'C:\CCStudio_v3.3\MyProjects\ad\cc_build_Debug.log': file too short

>> Compilation failure

（2），undefined first referenced

symbol in file

--------- ----------------

FS$$MPY

C:\CCStudio_v3.3\MyProjects\cputimer\Debug\DSP28_CpuTimers.obj

FS$$TOL

C:\CCStudio_v3.3\MyProjects\cputimer\Debug\DSP28_CpuTimers.obj

>> error: symbol referencing errors - './Debug/cputimer.out' not built

解决：将rts2800.lib项目连接的库改成rts2800_ml.lib

（3），Can't Run Target CPU: Can't write to data memory 0x950, check memory config [-2184] Can't Run Target CPU: Can't write to data memory 0x951, check memory config [-2184]

Can't Run Target CPU: Can't write to data memory 0x952, check memory config [-2184]

Can't Run Target CPU: Can't write to data memory 0x953, check memory config [-2184]

Can't Run Target CPU: Can't write to data memory 0x954, check memory config [-2184]

解决：// On TMX samples, to get the best performance of on chip RAM blocks M0/M1/L0/L1/H0 internal

// control registers bit have to be enabled. The bits are in Device emulation registers.

/* DevEmuRegs.M0RAMDFT = 0x0300;

DevEmuRegs.M1RAMDFT = 0x0300;

DevEmuRegs.L0RAMDFT = 0x0300;

DevEmuRegs.L1RAMDFT = 0x0300;

DevEmuRegs.H0RAMDFT = 0x0300;

*/直接删掉就行，那段代码是测试版为了提高性能的代码，到正式版的时候地址被保留，再加上的话就出错了

（4）,编译错误declaration may not appear after executable statement in block

系统初始化前没有进行变量的定义

如下例：InitSysCtrl();

unsigned int temp=0x0001; unsigned int i,j;

（5），编译警告：last line of file ends without a newline

解决：将光标移到提示告警的代码最后一行（有代码的那一行），然后按住del键，直到确定下面没有回车行，最后回车一下或多下即可。

（6），>> warning: creating .stack section with default size of 400 (hex) words.

Use

-stack option to change the default size.

解决：他是说，创建堆栈段使用与设置400个字，并建议在“堆栈操作”中改变这个与设置。这时，需要进行如下修改就可通过：project->build opration->Linker，在Stacte Size(-stact):填

入800或者其他小于1024的数值。再编译就不会报警了！

（7），编译警告：creating output section .switch without SECTIONS specification

解决：未添加.switch的段的分配

（8）"Zero.c", line 45: remark: function declared implicitly

解决：这是由于没有声明函数原型造成的。将函数的声明添加到“DSP281x_GlobalPrototypes.h”