toshiba LT084AC37100

Toshiba Matsushita Display Technology Co., Ltd
PRODUCT INFORMATION
21cm COLOR TFT-LCD MODULE (8.4 TYPE)
LT084AC37100 (p-Si TFT)
All information is subject to change without notice. Please read bottom notes.
REV REV ON OFF
PWM=100% PWM=100%
OPTICAL SPECIFICATION (Ta=25°C)
Item Contrast Ratio Viewing Angle (CR ≥ 10) Response Time (CR) (Upper+Lower) (Left+Right) (tON) (tOFF) Luminance (L) Lamp Life Time (MTBF)*2 *3 Min. (250) --------(220) Typ. (400) 100 120 8 17 320 70,000 Max. ------------Unit --° ° ms ms cd/m2 h Remarks Without T/P Without T/P Without T/P
PWM=100% PWM=100%
*2 : Conditions ;Ta=25°C, continuous lighting *3 : Definitions of failure ; 1) Lcd luminance becomes half of the minimum value. 2) LED doesn’t light normally. *The information contained herein is presented only as a guide for the applications of our products. No responsibility is assumed by Toshiba Matsushita Display Technology or other rights of the third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of Toshiba Matsushita Display Technology or others. *The information contained herein may be changed without prior notice. It is therefore advisable to contact Toshiba Matsushita Display Technology before proceeding with the design of equipment incorporating this product.
3+/-0.05 1+/-0.15 1+/-0.05 2R0 .4
4.0Min.(Support Board)
0.3+/-0.05
76.85(T/P FPC)
Standard tolerance : +/-0.5
127.872(active area)
127.8(T/P ACTIVE AREA)
2008-04-21 (Ver.0.1R)
(1/12)
2008-04-21 (Ver.0.1R)
LT084AC37100 <Touch Panel Condition> Recommended Operating Conditions
Item Supply Voltage VTP Min. --Min. 20 200 100 Typ. 5.0 Typ. ------Max. 7.0 Max. --1500 600 1.5 10 Min. 5 3 Typ. --Max. 50 Unit V Unit MOhm Ohm Ohm % msec Unit gf H Remarks Remarks
LT084AC37100
LT084AC37100 <Rear side>
TENTATIVE
Unit : mm Standard tolerance : +/-0.5
CN4(FPC for LED)
7.9+/-1
CN2
(4/12)
CN1
2008-04-21 (Ver.0.1R)
11+/-1
103.85+/-1 47.9+/-1
SEQUENCE OF POWER SUPPLIES AND SIGNALS
0.5ms (Min.) 10ms (Max.) 0.1ms (Min. ) 100ms (Max.)
500ms (Min.)
3.0V
3.0V
V DD CLK+/RxIN0+/RxIN1+/RxIN2+/-
0.2V
40ms (Max.) 0ms (Min.)
FEATURES: (1) 8.4” XGA color display with High Brightness (320cd/m2).
(2) Wide viewing angle and wide operating temperature. (3) Built in Long Life LEDs (MTBF:70,000 h). ( Conditions / Ta:25°C, PWM=100%(continuing lighting)) (4) Replaceable structure of LED units. (5) Mounting compatible with LTM08C351 series and LTA084C270F. (6) Resistance type touch panel assemble(4 wire, Except controller)
Mechanical Specifications
Item Operating Starting Force Surface Hardness
(2/12)
2008-04-21 (Ver.0.1R)
(YU) 199.5 (99.75) (99.75) 174.8(Bezel Opening) 170.496(LCD Active Area) 191.7 183.7(T/P) 170.4(T/P Active Area) 12.35 14.5 (XR) 7.9 3.9 7.9 (YD) 14.55
DIMENSIONAL OUTLINE <Front side>
(XR) (YU) (XL) (YD)
(XL)
Circuit Diagram
10.75
12.91 24.4 6.3
12.95
(76.85)
1+/-0.15
149.5
TENTATIVE
5+/-0.1
133.7(Bezel Ope RATINGS
Item Supply Voltage Input Signal Voltage Operating Temperature Storage Temperature Storage Humidity (Max. wet bulb temp. = 39°C) Item Supply Voltage Differential Input Voltage Common Mode Input Voltage High Level Input Voltage Low Level Input Voltage Backlight ON/OFF signal Luminance control signal Current Consumption Power Consumption*1
DETAIL A(2:1)
141.1(T/P)
0.45MAX
Unit : mm
3.0Min.(Contact)
(72.65)
104.9
(3/12)
80+/-1 A CN3
4-4 4-7 191.6 193.6
3.7+/-0.3
1.3
INSERTION INSPECTION MARK
13.0(with T/P)
Electrical Specifications
Item Insulation Resistance Resistance #1 - #3(X) between #2 - #4(Y) Terminals Linearity Chattering Z Rx Ry Remarks DC25V Measured at connector pin(including conductor resistance).
TENTATIVE
RoHS compatible
MECHANICAL SPECIFICATIONS
Item Dimensional Outline (Typ.) Number of Pixels Active Area Pixel Pitch Weight (approximately) Backlight Specifications 199.5 (W) x 149.5 (H) x 13.0 (D) mm 1024 (W) x 768 (H) pixels 170.496 (W) x 127.872 (H) mm 0.1665 (W) x 0.1665 (H) (TBD) Sidelight ( LEDs ) Min. -0.3 0 -0.3 -20 -30 10 Max. 4.0 20 VDD+0.3 70 80 90 Unit V V V °C °C %(RH)