5713FK-15B指纹锁的测试标准-061017

相关主题
  1. 1、下载文档前请自行甄别文档内容的完整性,平台不提供额外的编辑、内容补充、找答案等附加服务。
  2. 2、"仅部分预览"的文档,不可在线预览部分如存在完整性等问题,可反馈申请退款(可完整预览的文档不适用该条件!)。
  3. 3、如文档侵犯您的权益,请联系客服反馈,我们会尽快为您处理(人工客服工作时间:9:00-18:30)。

5713FK-15B指纹锁的测试标准

1.测试人群(Classification of people to be tested)

1.1.年龄分布(Range of age)

12 ~ 75岁

12 ~ 75 years old

1.2.取样方法(Sampling for fingers)

在1.1年龄段内平均取样,人种按当地实际使用人群比例取样。

The fingers should be sampled from different skin people in the local residents, and the age range should be apportioned according to item 1.1

1.3.手指状况(Status of fingerprint)

指纹纹理肉眼可分辨,无纹理或杂乱纹理的手指不参加测试。

The loop and whorls should be able to read visually, rough or non readable fingerprint loop should not be used for test.

1.4.职业状况(Status of career)

对手指损伤严重的行业不可选择为测试对象,损伤严重的判定标准参考

1.3。

If the fingerprint has been damaged which should not be chosen for test, the classification refer to item #1.3.

1.5.性别选择(Sex)

无要求。

Either man or woman.

1.6.测试手指(Finger to be tested)

除小指外的手指,因大部分人无法正确使用小指按压。

We suggest not to use pinkie, since most people is not able to lay the pinkie properly on the reader.

2.测试前的准备(The preparation before testing)

2.1.培训(Training)

必须要求被测试者阅读使用说明书,并且对被测试者进行必要的使用培

训以及正确的指纹按压方法的示范。正确按压方法的要求附在后面。

All tested people must be briefed with the instruction to press fingerprint on the reader, and also show them a correct way to press fingerprint as below mentioned.

2.2.对于干手指的处理方法(The solution for dry fingerprint)

由于当地气候环境的影响,有些人的指纹非常干燥,在按压指纹前要求适当地湿润手指,建议的方法是在自己的额头或者鼻子上反复摩擦数次,也可以对手指哈气。

Due to the mother of nature and environment, some people’s finger is dry and it must be misted before press his/her fingerprint, we may suggest that his/her fingerprint may be wiped on forehead or nose few time; they may also blow few breath to fingerprint.

3.测试内容和测试方法(The content and method of testing)

3.1.误识率的测试方法(The determination of False Acceptance Rate)

随机抽取50枚指纹登记到指纹锁内;另外安排50人(没有登记指纹)进行按压测试,每人每个手指的按压次数为4次。

Enroll any 50 fingerprints into the fingerprint lock, arrange the other 50 people which have never enrolled their fingerprints on the lock, each of their fingerprint shall be pressed 4 times on the reader.

3.2.拒真率的测试方法(The determination of False Rejection Rate)

保证被测试指纹符合要求的前提下,随机登记80枚指纹,并用这80枚进行按压通过测试,每一枚指纹最多进行5次按压。

A ll tested fingerprints should be matched with the mentioned criteria on the

classification of people to be tested. Enroll any 80 fingerprints into the locks and use this 80 fingerprints to open the lock, each registered fingerprint press 5 times at best.

3.3.比对时间的测试方法(The determination of Verification Time)

保证被测试指纹符合要求的前提下,随机登记50枚指纹,按压被测试指纹到采集窗上,听到笛的一声响开始计时,当判别结果的提示音出现的时候停止计时。

A ll tested fingerprints should be matched with the mentioned criteria on the

classification of people to be tested. Enroll any 50 fingerprints, each fingerprint should be counted by timer, the Verification Time start to count while the fingerprint press on the reader until hear the BIT sound from the lock.

相关文档
最新文档