金属探测器使用说明书

Metal detector manual

A description of each control key instrument

First, the button

There is a button at the bottom of the instrument, the instrument is very important in the adjustment of the instrument, the work process, often to press the button and relax. By pressing, then put the button inside the memory circuit automatically credited under the adjusted hungry working condition. If you forget to press, release the button, is bound to affect probing depth. Second, the tuning knob

Role tuner is bring up the "critical voice." The tuner clockwise from the left, first opened the power switch, as there continues to rotate, the sound from small to large. In the detection, should be transferred to a slight "buzzing" sound, the sound is very small, as long as can barely hear on the line, which is "critical voice." Only transferred to such faint sound of the instrument that has the highest sensitivity, if the "critical voice" tone too high or not tune out the sound of the instrument sensitivity will be reduced. Before tune "critical voice", be sure to press the button, and then release the button after a good tune. If the detection process, "critical voice" gradually increase or decrease or even disappear, press the release button to make a "critical voice" resume again after detection.

After the instrument is completed, the tuner is screwed counter-clockwise to the left end of the Turn off the power, do not let the instrument open supply vacant.

Third, the operation mode switch

Operating mode switch has two positions, one is the balance, and the other is identified.

The switch radially balanced profile, the instrument beeps for all metals will, and can eliminate the influence of "mineralization reaction". If you put the switch to identify the file, the instrument can distinguish between different types of metal.

Fourth, work adjustment knob

Work adjustment knob is used with the operating mode switch it around labeled 0-10 scale. When balanced mode of operation, by adjusting the knob can be ruled out "mineralization reaction"; in identifying operating mode, use it to distinguish between different types of metal.

Five, headphone jack

Instrument can be equipped with plug headphones, then plug in headphones, speakers sound interrupted, the operator can hear the sound from the headphones, so that in a noisy environment or night operations.

Metal detection method

Detector operation like mine engineer, probing, the probe with the ground to maintain a distance of 10 cm, parallel movement on the ground. Probe not lift too high, so as not to decrease the actual depth of the probe.

One, balanced way

This way to get rid of the earth "mineralization reaction" and has better penetration, so no matter indoor or outdoor job search, this approach is often preferred. Proved the existence of underground metal only after identifying files to identify with the type of metal. In balance mode of operation, as long as the probe is moved to the top of the target, the instrument will send a continuous sound, any type of metal will make the sound increases, meter readings rise.