澳洲钢材标准对应国际标准

XLERPLATE ®General range products 17

16 XLERPLATE ®

General range products

BOILER AND PRESSURE VESSEL PLATE

STRUCTURAL STEEL PLATE Based on Tensile Strength

International Standards Comparison

2.For grades with BOLD suffix letters C, D on British, European and International Standards,B, C on Japanese Standards and suffix numbers 2and 3on German Standards, the appropriate Australian alternative is the nearest L15grade of the equivalent strength level (ie High or Medium).

3.Grades most readily available from BlueScope Steel are 250, 250L15, 350, 350L15.

4.This table is designed to allow customers to determine the nearest available Australian grade to an international specification.It should not be used in reverse.

requirement than the corresponding AS1548-7-490 and equivalent grades.3.Grade equivalence shown is based on room temperature tensile properties only.4.Grades readily available from BlueScope Steel are shown in bold type.

5.*ASTM A662 Grade B & C are dual certified with AS1548-7-460 & 7-490 respectively, in thickness 8-40mm

6.#These overseas grades may be available subject to enquiry.

7.It may be possible to substitute readily available BlueScope Steel grades for international grades outside the designated strength band shown, provided relevant design factors are considered. Refer to BlueScope Steel Direct - 1800 800 789 within Australia.

8.This table is designed to allow customers to determine the nearest available Australian grade to an international specification.It should not be used in reverse.

PRODUCT INFORMATION

© Edition 2, November 2003BlueScope Steel Limited ABN 16 000 011 058.

XLER ®,XLERPLATE ®,XLERCOIL ®,COLORBOND ®, and ZINCALUME ®,are registered trademarks of BlueScope Steel Limited. LASERCUT ™is a trademark of BlueScope Steel Limited.BlueScope is a trademark of BlueScope Steel Limited.Certain copyright tables in this brochure are reproduced with the permission of Standards Australia.

9320075 034979

The information contained in this product brochure is provided by way of general information only, and should not by relied upon by any person. You must seek specific advice as to the suitability of the products featured in this brochure for the purpose of which, and the manner in which, you propose to use them. This may involve further independent analysis and testing. BlueScope Steel Limited, and its related bodies corporate take no responsibility for any adverse consequences of any nature which arises as a result of reliance on this brochure.

XLERPLATE ®& XLERCOIL ®Product Information