SGS家用电器检验标准(全英文)

的产品要符合UL或CSA标准

测试指（刚性、有关节）、试验探棒、试验销冲击球、力矩螺刀、力矩扳手、拉/压力计等

设备

容性(EMC)试验

-10%

及≤300 +20%

+15%或60W（取大）

7

位

逐渐升到测试电压的一半，然后迅速升到规定值1min,观察有无闪络或击穿

逐渐降低电压至零

0.5(0I类)/3.5(I类)

3.5

最后受力)

至少由2层组成,且任一层可通过SI的耐压测试;RI至层可通过RI的耐压测试.

胶带破损度应小于50%.

的规范性

境温度

间隙

它金属件之间

强度

起痕

General checking Item

1.1 Carton and gift box

•Carton and giftbox shall be firmly and up corrugation wave direction. No damaged, no wetted and no dirty.

•All marks shall clear and correct.

•Check if the item No, model No and pork ……are correct and no missing.

1.2 Packing polybag

•No damaged, no dirty and shall drying.

•Shall have related warning words and punch hole on polybag.

Note: No need warning words and punch hole on polybag if the polybag is less than 100x100mm2and open perimeter is less than 380mm.

1.3 Package

Check if the carton and giftbox packed the unit fitly. Too large and too small will

reduce the protection for unit.

All carton or giftbox shall stand packing and placing along corrugation direction.

Otherwise, package will reduce its protection function.

General checking Item

1.4 Label and manual

•The marking shall be clearly legible and durable.

Rubbing test for 15 s with a piece of cloth soaked with water and again for 15 s with a piece of cloth soaked with petroleum spirit.

•To check if there are following marking marked on appliances.

--rated voltage (ranges)

--rated frequency

--rated input

--maker’s or responsible vendor’s name, trade mark or identification mark.

--maker’s model or type reference.

--symbol for class II construction, for class II appliances only.

--symbol for degree of protection against ingress of water, other than IPX0.•Generally, appliance shall be with a manual to tell how to use the appliance. It shall be clearly and correct.

General checking Item

1.5 Power cord

•No damaged and all marks shall be clearly legible and durable.

•Check if there are related safety approved marks and related license No. Actual record all marks in inspection report.

•For UL product:

The power cord shall be withstand a pull of 155.68N (35 pounds) for 1 minute without displacement

•For EN product:

The power cord shall have a cord anchorage and shall be withstand a pull of 30N for mass less than 1 kg, of 60N for mass less than 4kg, for 25 times with

displacement within 2mm

General checking Item

1.6 Plug

No damaged and no burr. The pins shall be not loosen.

Check if there are related safety approved marks and related license No. Actual record all marks in inspection report.

•For UK plug:

Level II internal check UK plug. No wire strand protruding from connector. Check the manufacturer marks on plug, such as PMS, MS, scolmore.

The fuse holder shall attached to the live pin correctly.

Check if it is a counterfeit fuse. Check the manufacturer marks, such as Bussmann ASTA.

The weight of genuine fuse is normally between 2.3 –2.4g and with a small central hollow at end cap.