设备保养记录表格式

NO 点检内容（Item)

123456789101112131415161718192021222324252627282930311确认主机电源接头无松脱

Check Main Power Connection 2清楚机内非相关异物Clear Obiects Inside Machine

3用软布清洁亚克力面板

Clean the Front Cover Screen 4确认周围环境条件（电压/温湿度..）Environment(Voltage/Temperature…)5确认紧急停止流程致能及正常Check Emergencv Stop Procedure 6确认机体风扇正常运转Check Back Fans Operating

7确认三色灯灯号正常Signal Tower Lighting and Buzzer 8确认屏幕Cabie连接无脱落Check Screen Cable Connection

1用软布擦拭清洁人机界面(*)Clean the Touch Panel(*)

2检查面板接头有无松脱

Check the Motor and Sensor Connection 3清洁皮带传动轮Check and Cleab Belt Wheels 4确认KeySwitch停止流程致能及正常Check the KeySwitch Process 5清洁前门滤网Clean the Front Filters

6清洁皮带上松香黏渍物Clean the Flux on Convever

7清洁气压过滤器

Clean Air Filter

1

线性滑轨加润滑保养（擦拭旧油）Lubricate the Linear Guides(wipe the old oil)2滚珠螺杆加润滑保养（擦拭旧油）

Lubricate the Ballscrews(wipe the old oil)3确认铸件平台防锈油是否足够

Confirm rust preventing oil on iron casting 4前机门滤网清洁Clean Filters on Front Doors 5PC风扇滤网清洁Clean Filter and Fans on Main PC 6清洁机体后侧风扇Clean Back Fans

7擦拭清洁传感器表面Clean the Sensors 8清洁LCD Monitor Clean LCD Monitor

技术员Technician 课长或工程师Leader or Enginner 2.记录符号Mark:V 正常/OK x 故障要修理/NG △要注意/PAY ATTENTION 2.（*）如果有此此设备才需检查

If Equipment Exist Then Chenck It 周保养（w e e k l y )月保养（m o n t h ）担当

Prepared

确认

Approve

备注

Remark 设备保养记录表

1.生技人员每日生产前实施检查Technician Need To Check the Item Before Working Solder Paste Inspection Maintain Record

日保养（d a i l y )