种树施工方案简单

越南福和闸堰项目

植树施工方案

中国水利水电建设集团国际工程有限公司越南福和闸堰项目部

二○一一年九月十五日

1、概述及主要工程量

越南福和闸堰项目植树面积49.27公顷。分布于左岸进场道路旁边，业主管理房周围，和土坝下游区域。

2、施工工艺流程及主要施工方法

施工工艺流程：

表（层）面处理→测量定位→挖种植穴→树苗检查→植树→养护。

2.1 表（层）面处理：

需要植树的部位用推土机大致推平，铲除表面的杂草，灌木等影响树木生长的杂物。

2.2定点放样

测量人员进行定点的放样，严格按照一公顷面积植树440棵放样（即植树间距4.77米），测量后做明显标记。

2.3挖种植穴：

种植穴直径60cm，深度为60cm，要求坑壁光滑，上下面口径基本一致。

2.4树苗检查

树干挺直，没有明显弯曲，无蛀干害虫和未愈合的机械损伤；树冠丰满，枝条分布均匀、无严重病虫危害，树叶正常；根系发育良好、无严重病虫危害；土球大小为苗木胸径的10倍以上。

2.5植树

2.5.1种植的质量标准：

种植的苗木品种为景观树柚树，苗木的本身与地面垂直，没有倾斜；严格按照测量定点种植，横平竖直，树木应在一条直线上；树苗高度为1.5米左右，相邻两株高差不超过30cm；种植深浅与原土痕持平；保持树苗土球完好，包装物

应取出。

2.5.2种植的程序和方法：

树木入穴后，土球放稳，树干直立，拆除并取出包装物；种植后在树木四周筑成高5－10cm的灌水土堰，方便浇水；种植后需要支撑的树木，用树枝或者竹竿支撑牢固，使树木保持直立；新植树木24小时内浇第一遍水，三日内浇第二遍水，十日内浇上第三遍水，三遍水后转入后期养护；每次浇水后均整堰、堵漏、培土、扶直树干，第三遍水后封堰。

2.6养护：

新植树苗完成后进行养护，主要项目包括：浇水、、防治病虫、补栽未成活树苗、直至交付验收。

3、施工设备及人员配置

3.1施工设备

3.2主要劳动力配置

主要劳动力配置表

Contract 1A Phuoc Hoa Headworks Construction Method for Tree Planting

September 15th 2011

1、General including main construction quantities

The tree planting area for the Vietnam Phuoc Hoa headworks occupied 49.27ha mainly distributed at two sides of the left bank access road, the surrounding of the Employer’s management house and the downstream area of the earth dam.

2、Construction Process and Main Method

Construction Process:

Surface Treatment→Survey for positioning→Pit Excavation →Checking of the Sapling→Planting→Maintenance

2.1 Surface Treatment：

Level the planting area by bulldozer, and remove the weeds and bushes at the surface which will impact the growing of the trees.

2.2 Setting Out

Setting out by the survey staff, strictly keeping the spacing by 4.77m based on 440 trees per ha, and make marks after setting out.

2.3 Excavation of the Planting Pits：

The planting pits will be excavated with dia 60cm and 60cm of depth, with smooth walls, consistent dimensions for the opening and the bottom part.

2.4 Checking of the Sapling

Sapling should be straight body, no obvious bending, no harm by the insects or physical surface injury; rich crown with evenly distributed branches without any disease or harmful insects, with healthy leaves; grown root without any disease or harmful insects; soil ball should be 10 times larger than the diameter of the breast branch of the sapling.

2.5 Planting

2.5.1 Quality Standard：

The category of the sapling to plant is teak as landscape trees. The sapling itself should be plated vertically toward the land without any slant. The trees should be planted strictly according to the setting out points, ordered in rows and lines with