试模参数记录表
6th 段5th 段3rd 段4th 段监视项目tail item 6th 段5th 段IP IV
1st 段2nd 段5
气辅参数Gas parameter 模具实际温度 (仅供参考)Mold fact temp(FYI)
型芯设定Core Setting
mm 3、4此模是属belong to :正常啤塑(满足生产时)fit to produce 非正常啤塑(啤样板)only fit to mold trial
记录人reporter (试模员):___ _ 试模组长确认confirmed by : 工程师审核approved by :___ ________
吹气感应位置:
position of gas blowing mm
SEC SEC 32ton kgf 试模参数记录表 TRIAL REPORT
模号Mold NO.:_ _ 机型Machine range :___ _ _试模次数Trial times :__ __ 日期Date :_ _____倒索P.B.
射胶保压INJ/HP 冷却时间Cooling time 周期时间Cycle
射胶压力 Inj. pres kgf
复位方式Return method 顶出长度EJ pos.
kgf
回料转速Sc.Speed 11P
SEC MM
剩余胶量Cushion mm 保压切换
Transfer 保压切换Transfer
速度IV T
后模Core
2、2、
rpm sec 延时: sec Delay 背压力B.P.
3、后模运水Core cooling
计量时间Recov. Time ←保压
H.P.←射胶INJ.锁模力Clamp frc.
31组1team T
mm 后模Core
V
前模运水
Cavity cooling 氮气总压力Nitrogen gas press : PS1前模Cavity 1、1、
P
5
2、
2V
2组 2team 延时: sec Delay
3、
41、1、
2、3、
前模Cavity 入芯状态Core SET
抽芯状态Core PULL
顶棍间距Distance EJ 回料速度RS 背压BP
射胶时间Inj.time mm 计量完成measure
sec mm
模具厚度 Mold thickness 烤炉温度Hoppr temp.
5
胶料名称Type of Plastic 颜色Colour 段数st 4
3
4th 段3rd 段2nd 段炮筒温度0C Temp. of 热流道温度0C Temp.of Hot
1st 段
6
1
2
备注Remark :
SEC
HP 40C
50C
6
0C
1
0C
2
0C
3
0C