手动挡汽车驾驶技巧(Manual car driving skills)

手动挡汽车驾驶技巧（Manual car driving skills）手动挡汽车驾驶技巧(Manual car driving skills)The operating principle about: General intersection stop at the stop line is not running, this is because the intersection condition allows, in the design of the general line in the parking lot outside thedistance is relatively flat, to prevent slipping, except in special circumstances. After entering the intersection is not the same, at the intersection of design and in the construction, at the center of the intersection points higher, so, clutch, parking, do not lift the foot brake, the waiting time is short, the clutch pressure. The gear is not removed (if it is two block above, should be directly linked into a file, ready to start), start, right foot brake loose throttle back quickly at the same time, according to the number, size and moderate passenger ramp refueling, left at the same time quickly lifted to the car (called semi professional linkage), just to keep up with the throttle, slowly liftthe clutch smooth start. As long as the left foot and with a good And quickly is not slipping and flameout, Why loose foot brake left footwith a good car will not slip in speak about: divided into automobile brake and the hand brake, foot brake and brake control function is called, the vehicle deceleration and parking. The hand brake is also called the parking brake, its role is to ensure that the car parking without slip, emergency braking, and can be used at the same time with the foot brake.Ensure that the car does not slip ramp car at least one condition:A pull hand brake.Two, step on the foot brake and maintain sufficient brakingforce.Three, half linkage and can overcome the resistance of the downhill.Four, gear (low gear is not easy to slip) lift the clutch, engine traction resistance should be greater than the downhill slope resistance. The foot brake, foot brake loose, a condition of vehicle are not, whynot start quickly slip? Because the loose brake pedal, to completely remove the brake for some time, the reaction time of the braking system is professional, at this time, the left foot onto the car (half linkage), right foot timely refueling, slowly lift the clutch, ensure that the car does not slip, not channeling, no flame, is not a smooth start the problem about whether to lift the clutch pedal. Low can start to answer the question: the function of the clutch can combine the power and transmission system of the engine is temporarily separated and stable,so that the car shift or smooth start. The clutch pedal car (left foot) by external force can move downward, lift the clutch pedal force, clutch in the spring, the pedal plate separation bearing return spring, pedal return spring, jumps to the pedal down movement of the clutch pedaltravel professional call for Cheng. Above the lighter motion stroke, called the clutch pedal free stroke, down until the end of this trip is called the clutch pedal stroke, clutch pedal free travel is generally 20- 40 mm. Too large, pedal lift can go, but it is easy to cause the separation is not complete, the gear is not easy...The manual driving the most reasonable shift the way [driving skills] Clutch pieceThe car driving manual to do with hands and feet, if the action isnot harmonious, will become confused, not only difficult to control, but also can damage the clutch.Attention control clutch:1. the right clutch posture, my foot on the clutch pedal, heel toclose to the ground, when the clutch is stepped on to the lowest point,to keep the knees slightly bent. Do not trample on tiptoe or heel offthe ground, to avoid not enough strength or decline.2. clutch, stepped on to the lowest (floor), avoid long time in half joint state, so it can ensure the complete separation of the clutch, soas not to wear.3. clutch when driving, do not put too fast or deliberately enhancethe engine speed is too high, it will accelerate the loss of clutch.The 4. step is always in low shift clutch.5. clutch, throttle should be open.6. if not smooth shift, can first and then release the clutch, the clutch once again shift, do not force the shift, or make thetransmission gear friction.7. Road, not the right foot on the clutch.A gestureEveryone singing the gesture will be different, the different gestures shift car when driving manual.In fact, since there is a manual car so far, did not have a completely correct gesture shift rules, because of the shift of each person's gestures are not the same, but how can change smoothly, comfortable, but enough to affect the accuracy and safety of thedriver's confidence, shift. The following provides a set of popular gestures, for your reference novice.Add blockNeutral - 1 block: block to the inside of his right hand push, then go into the 1 block.Block 1, block 2: hold the gear handle, the pull down into the 2 blockBlock 2, block 3: hand block into 3 block.Block 3, block 4: with the palm light on dangba, separating the fingers downward into the catch block, 4 block, hand still wrapped in dangba.4 block,5 block: block the backhand outward, then into the 5 block.The reduction gearBlock 5, block 4, block in the 5 down dangba, starting 4 block.Block 4, block 3: hold dangba, into the 3 block.Block 3, block 2, block 2: push down.Block 2, block 1, into the 1 block.Shift reportWhat is the best time to shift? This is a lot of manual driver problems. Many people think that the silent shift is correct, so the engine has not yet reached the best rotation when the blind shift, this was also not a bad idea, but just compare the fuel consumption. Because the rotation is too low, the driver must increase the amount of oil, in order to maintain the normal power output, the engine output torque peak in driving is close to the speed, is the most fuel-efficient.The 1.5 litre family car on the road to walk on as an example, the most ideal shifting time is as follows:1 block start: About 1500rpm1 block turn2 block: 20km/h2 block turn3 Block: 30km/h3 block turn4 block: 40km/h4 block turn5 block: 50km/hTo resist is the same, don't wait for low speed vehicle, almost no effort to reduce the block, it will increase the engine load. To keep the vehicle driving force and speed of the engine, reduce the burden as soon as possible the reduction gear is necessary, especially when the vehicle running uphill, slow loading and running.Generally speaking, the best time of the reduction gear is as follows:5 gear to 4 gear: 55km/h4 gear to 3 gear: 45km/h3 gear to 2 gear: 35km/h2 gear to 1 gear: 25km/h。