电源线摇摆测试报告 2019.3.15
1. Test diagram 测试图示
2. Test result 测试结果
Approval 核准:Checked 审核:
Producer 制作:
Note 备注According to 参考 标准Sample No.样品编号
5#Match condition 符合条件 □
Cycles
Judgement 综合判定
□ PASS 合格 □ NG 不合格
3#Match condition 符合条件 □ Cycles 4#Match condition 符合条件 □ Cycles 1#Match condition 符合条件 □ Cycles
2#Match condition 符合条件 □ Cycles Test result description 结果描述
Judgement 判定
耐压测试
Test Cycles 测试次数
绞线丝断裂≤10%
Test Item 测试项目Cycle Bending Test 循环摇摆测试Test Requirement 测 试 要 求
hand-blender 手持搅拌器,需要做两个测试(IEC60335-1 AND IEC60335-2-14).测试条件如下:第一: The supply cord is suspended vertically from the appliance and loaded so that a force of 10 N is applied. The oscillating part is moved through an angle of 180° and back to the initial position. The number of flexings is 2 000, the rate of flexing being six per minute.最初电源软线垂直悬挂并施加一个10N 的力(砝码).振荡部分的移动为通过180°并回到初始位置来过行.弯曲次数为2000次,弯曲速率为6次/min.
注:器具的安装应使弯曲的方向与电源软线在其贮线处缠绕所产生的方向一致(钟摆方向).第二:The oscillating member is moved through an angle of 90° (45° on either side of the vertical), the number of flexings for type Z attachments being 20 000 and for other attachments 10 000. The rate of flexing is 60 per minute.对电源软线施加5N 的力,摆动件以90° (在垂线的两侧各45度)摆动10000次, 60次/min 注:一次弯曲为一个90° 运动.
试验期间,对器具的导线施加额定电压和额定电流的负载.
试验不应导致: 导线之间的短路/任何一根多股线中的绞线丝断裂超过10%/导线从它的接线端子上脱开/导线保护装置的松开/软线或软线防护装置的损坏/断裂的绞线穿透绝缘层并且成为易触及的导电体.
Result of measurement 测 试 结 果■正负90度摇摆
□正负45度摇摆
Product spec.
产品规格
Test machine 测试设备
Cycle Bending Test machine
循环摇摆测试机:Test environment
测试环境温度:25℃/湿度:75%
Customer
客户名称/
Part/No.产品料号
/
Drawing NO.工程图号
/
Cycle Bending Test Report 摇 摆 测 试 报 告
Product name 产品名称
Sample Q'ty 样品数量
各 PCS
Test date 测试日期
NO.报告编号:
90
°
90
°
荷重
Weight Stopper 平衡杆
夾具Fixing portion Fixing portion 夾具